DTC B1511-87: Lost Communication with Meter Gigabit Video Interface Missing Message [11/2021 - 10/2023]: Procedure

1. Check for DTCs and the output pattern according to the following table.

   Refer to DTC CHECK / CLEAR [10/2017 - ]

   Body Electrical > Combination Meter > Trouble Codes 

2. Check for DTCs and the output pattern according to the following table.

   Refer to DTC CHECK / CLEAR [10/2017 - 10/2023]

   Body Electrical > Head Up Display > Trouble Codes 

   Pattern	DTC Output Part Name (Display on GTS)
   	Meter mirror sub-assembly (Head Up Display)	Combination meter assembly (Combination Meter)
   	B1511-87	B1510-87
   Pattern 1	◦	◦
   Pattern 2	◦	-

   ◦: DTC is output.-: DTC is not output

   Result

   Result	Proceed to
   Pattern 1	A
   Pattern 2	B

Result: 

A 

GO TO METER / GAUGE SYSTEM (B1510-87). Refer to  DTC B1510-87: Lost Communication with HUD Gigabit Video Interface Missing Message [11/2021 - 10/2023] 

Result: 

B 

See step  2

1. Disconnect the G179 combination meter assembly connector.
2. Disconnect the G178 meter mirror sub-assembly connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   G179-1 (MGV+) - G178-2 (HGV+)	Always	Below 1 Ω
   G179-2 (MGV-) - G178-1 (HGV-)	Always	Below 1 Ω
   G179-3 (MGVG) - G178-3 (HGVG)	Always	Below 1 Ω
   G179-1 (MGV+) or G178-2 (HGV+) - Body ground	Always	10 kΩ or higher
   G179-2 (MGV-) or G178-1 (HGV-) - Body ground	Always	10 kΩ or higher
   G179-3 (MGVG) or G178-3 (HGVG) - Body ground	Always	10 kΩ or higher

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE METER MIRROR SUB-ASSEMBLY. Refer to  REMOVAL [11/2021 - 10/2022]  , or refer to  REMOVAL [10/2022 - 10/2023] 

Result: 

NG 

REPAIR OR REPLACE GVIF CABLE OR CONNECTOR (GVIF CABLE)