Installation [10/2023 - ]: Procedure
- INSTALL DISC BRAKE AIR GUIDE PLATE
Refer to PROCEDURE - Step 1
- INSTALL FRONT AXLE HUB SUB-ASSEMBLY LH
Refer to PROCEDURE - Step 2
- TEMPORARILY INSTALL STEERING KNUCKLE LH
- Temporarily install the steering knuckle LH with the 3 bolts.
- CONNECT FRONT SUSPENSION UPPER ARM ASSEMBLY
Refer to PROCEDURE - Step 10
- TIGHTEN STEERING KNUCKLE LH
- Tighten the steering knuckle LH with the 3 bolts.
Torque: 112.7 N.m (1149 kgf/cm, 83 ft.lbf)
- Tighten the steering knuckle LH with the 3 bolts.
- CONNECT TIE ROD ASSEMBLY LH
Refer to PROCEDURE - Step 2
- INSTALL FRONT AXLE SHAFT NUT LH
Refer to PROCEDURE - Step 7
- INSTALL FRONT DISC BRAKE DUST COVER LH
Refer to PROCEDURE - Step 8
- INSPECT FRONT AXLE HUB BEARING LOOSENESS
Refer to PROCEDURE - Step 5
- INSPECT FRONT AXLE HUB RUNOUT
Refer to PROCEDURE - Step 6
- STAKE FRONT AXLE SHAFT NUT LH
Refer to PROCEDURE - Step 11
- INSTALL FRONT DISC LH
- for 6-Pot Caliper
Refer to PROCEDURE - Step 1
- except 6-Pot Caliper
- for 6-Pot Caliper
- CONNECT DISC BRAKE CYLINDER ASSEMBLY
Refer to PROCEDURE - Step 13
- CONNECT FRONT SPEED SENSOR WIRE
Refer to PROCEDURE - Step 14
- STABILIZE SUSPENSION
Refer to PROCEDURE - Step 8
- INSTALL STRUT BAR BRACKET SUPPORT SUB-ASSEMBLY
Refer to PROCEDURE - Step 179
- INSTALL NO. 2 ENGINE UNDER COVER ASSEMBLY
Refer to PROCEDURE - Step 181
- INSTALL NO. 1 ENGINE UNDER COVER ASSEMBLY
Refer to PROCEDURE - Step 183
- INSTALL FRONT WHEEL
Refer to INSTALLATION [10/2023 - ]
- CHECK FOR SPEED SENSOR SIGNAL
Refer to TEST MODE PROCEDURE [10/2023 - ]
- INSPECT AND ADJUST FRONT WHEEL ALIGNMENT
Refer to ADJUSTMENT [10/2023 - ]
- INSPECT AND ADJUST VEHICLE HEIGHT (w/ Air Suspension)
Refer to ADJUSTMENT [10/2023 - ]
- PERFORM INITIALIZATION
Refer to WORK PROCEDURE [10/2023 - ]
- ADJUST HEADLIGHT AIMING
Refer to PROCEDURE - Step 4