Removal [12/2017 - 09/2018]: Procedure

PRECAUTION

WARNING:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Refer to PRECAUTION [12/2017 - 10/2020]

NOTE:

After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Refer to PRECAUTION [12/2017 - 10/2020]

REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY
Refer to PROCEDURE - Step 24

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Refer to PROCEDURE - Step 3

WARNING:

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
Refer to PRECAUTION [12/2017 - 10/2020]
If the airbag deploys for any reason, it may cause a serious accident.

NOTE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Refer to INITIALIZATION [12/2017 - 09/2018]

REMOVE AIR CONDITIONING UNIT ASSEMBLY
Refer to REMOVAL [12/2017 - 09/2018]

REMOVE ID CODE BOX (IMMOBILIZER CODE ECU)

NOTE:

Do not reuse dropped or damaged parts.

Detach the claw as shown in the illustration.

	Remove in this Direction (1)
	Remove in this Direction (2)

Detach the claw to remove the ID code box (immobiliser code ECU) as shown in the illustration.

Remove in this Direction