LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2019 >> LS 500 Base, RWD >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Meter / Gauge / Display - Service Information >> Combination Meter >> Installation [10/2023 - ] >> Procedure

Installation [10/2023 - ]: Procedure

  1. INSTALL COMBINATION METER ASSEMBLY 
    1. GTY1240438Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Connect the 4 connectors and attach the wire harness clamp.

    2. Insert the pin and set the combination meter assembly in the direction of the arrow shown in the illustration.
      GTY1235830Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Install in this Direction
    3. Install the combination meter assembly with the 4 screws.
      GTY1239689Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Attach the clamp.
  2. INSTALL INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY 
    1. Connect the connector.
      GTY1234304Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. GTY1232915Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Install in this Direction

      Insert the guide and attach the clip to install the instrument cluster finish panel assembly in the direction of the arrow shown in the illustration.

    3. GTY1229708Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Install in this Direction

      Push the direction of the arrow in the illustration to insert the guide and attach the claw.

  3. INSTALL INSTRUMENT CLUSTER FINISH PANEL GARNISH ASSEMBLY 

    Refer to PROCEDURE - Step 22

  4. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY 

    Refer to PROCEDURE - Step 24

  5. INSTALL INSTRUMENT PANEL SAFETY PAD INSERT SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 25

  6. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 26

  7. INSTALL NO. 1 INSTRUMENT PANEL SAFETY PAD 

    Refer to PROCEDURE - Step 29

  8. INSTALL NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 30

  9. INSTALL LOWER NO. 1 INSTRUMENT PANEL PAD SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 32

  10. INSTALL INSTRUMENT SIDE PANEL LH 

    Refer to PROCEDURE - Step 35

  11. INSTALL INSTRUMENT SIDE PANEL RH 

    Refer to PROCEDURE - Step 39

  12. UPDATE ECU SECURITY KEY 

    Refer to UPDATE ECU SECURITY KEY [10/2023 - ]

  13. CUSTOMIZE POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM 
    1. Reset the auto tilt away function setting to the previous condition by changing the customize parameter.

      Refer to CUSTOMIZE PARAMETERS [12/2017 - ]

scientia non olet · About LEMON Manuals