Removal [03/2017 - 09/2023]: Procedure

Refer to PROCEDURE - Step 13 [03/2017 - 05/2023] , or refer to PROCEDURE - Step 13 [05/2023 - 09/2023]

Refer to PROCEDURE - Step 14 [03/2017 - 05/2023] , or refer to PROCEDURE - Step 14 [05/2023 - 09/2023]

Refer to PROCEDURE - Step 15 [03/2017 - 05/2023] , or refer to PROCEDURE - Step 15 [05/2023 - 09/2023]

1. Remove the 2 nuts and front stabilizer link assembly LH from the lower No. 2 suspension arm assembly LH and front stabilizer bar.

   HINT: 

   If the ball joint turns together with the nut, use a 8 mm hexagon wrench to hold the stud bolt.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

HINT: 

Perform the same procedure as for the LH side.

1. Remove the 4 bolts and 4 nuts, and front stabilizer bar.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   HINT: 

   • The stabilizer bracket and bush are built onto the stabilizer bar. If the bracket and/or bush detach from the bar, replace the bar.
   • Be careful not to drop the nuts.