Installation [03/2017 - 09/2023]: Procedure

INSTALL FRONT STABILIZER BAR

Install the front stabilizer bar with the 4 bolts and 4 nuts.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Torque: 120 N.m (1224 kgf/cm, 89 ft.lbf)

NOTE:

Temporarily tighten the bolt (A), and then fully tighten the 4 bolts in the order of (B), (C), (D), and (A).

INSTALL FRONT STABILIZER LINK ASSEMBLY LH
1. Install the front stabilizer link assembly LH to the lower No. 2 suspension arm assembly LH and front stabilizer bar with the 2 nuts.
  Torque: 125 N.m (1275 kgf/cm, 92 ft.lbf)
  
  HINT:
  
  If the ball joint turns together with the nut, use a 8 mm hexagon wrench to hold the stud bolt.
INSTALL FRONT STABILIZER LINK ASSEMBLY RH
HINT:

Perform the same procedure as for the LH side.
INSTALL STRUT BAR BRACKET SUPPORT SUB-ASSEMBLY
Refer to PROCEDURE - Step 132 [03/2017 - 06/2019] , or refer to PROCEDURE - Step 132 [06/2019 - 05/2023] , or refer to PROCEDURE - Step 135 [05/2023 - 09/2023]
INSTALL NO. 2 ENGINE UNDER COVER ASSEMBLY
Refer to PROCEDURE - Step 133 [03/2017 - 06/2019] , or refer to PROCEDURE - Step 133 [06/2019 - 05/2023] , or refer to PROCEDURE - Step 136 [05/2023 - 09/2023]
INSTALL NO. 1 ENGINE UNDER COVER ASSEMBLY
Refer to PROCEDURE - Step 134 [03/2017 - 06/2019] , or refer to PROCEDURE - Step 134 [06/2019 - 05/2023] , or refer to PROCEDURE - Step 137 [05/2023 - 09/2023]