Removal [05/2023 - ]: Procedure

Refer to REMOVAL [05/2023 - ]

1. Using SST, hold the crankshaft pulley.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   • SST: 09213-38010 
     1. 09214-00011
   • SST: 09330-00021 
2. Remove the 10 bolts, rear drive plate spacer, drive plate and ring gear sub-assembly and crankshaft angle sensor rotor.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Using a knife, cut through the lip of the engine rear oil seal.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Cut Position
   *b	Protective Tape

2. Using a screwdriver, pry out the engine rear oil seal.
   NOTE:

   After removal, check the crankshaft for damage.

   If it is damaged, smooth the surface with 400-grit sandpaper.

   HINT: 

   Tape the screwdriver tip before use.