Removal [03/2017 - 05/2023]: Procedure

PRECAUTION
NOTE:
After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Refer to PRECAUTION [03/2017 - 05/2023]
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Refer to INITIALIZATION [03/2017 - 04/2020] , or refer to INITIALIZATION [04/2020 - 05/2023]
REMOVE OIL COOLER ASSEMBLY
Refer to REMOVAL [03/2017 - 05/2023]
REMOVE FAN AND GENERATOR V BELT
Refer to REMOVAL [03/2017 - ]

REMOVE FRONT STABILIZER BAR BRACKET BOLT

Remove the bolt and specer nut from the front frame crossmenber sub-assembly.

GTY795503

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

REMOVE GENERATOR ASSEMBLY

Detach the 2 clamps.

GTY831773

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Remove the bolt and disconnect the engine wire.

Remove the terminal cap.

GTY790231

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

*1	Terminal Cap
*2	Oil Cooler Tube
*a	Bolt
*b	Nut

Detach the clamp.
Remove the nut and disconnect the engine wire from terminal B.
Disconnect the generator assembly connector.
Remove the bolt and disconnect the oil cooler tube.

Remove the bolt and oil cooler bracket.

GTY795504

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Remove the bolt A and engine wire bracket.

GTY838116

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

*1	Engine Wire Bracket

Remove the bolt B and 2 nuts.

Using an E8 "TORX" socket wrench, remove the 2 stud bolts and generator assembly.

GTY795489

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Remove the bolt and wire harness bracket from the generator assembly.