VSC does not Operate or VSC does not Operate Correctly [03/2017 - ]: Procedure

1. Check whether the slip indicator light was illuminated when VSC did not operate.

   OK

   The slip indicator light was illuminated.

   HINT: 

   When a DTC is stored, the slip indicator light is illuminated and VSC does not operate due to the fail-safe function.

2. Check whether the vehicle speed was 15 km/h (9 mph) or less when VSC did not operate.

   OK

   The vehicle speed was 15 km/h (9 mph) or less.

   HINT: 

   VSC does not operate when the vehicle speed is 15 km/h (9 mph) or less.

3. Check whether the vehicle was driven straight for a few seconds at 35 km/h (22 mph) or more.

   OK

   The vehicle was not driven straight for a few seconds at 35 km/h (22 mph) or more.

   HINT: 

   When the engine switch is turned on (IG), as steering sensor zero point calibration is not performed below 35 km/h (22 mph), VSC will not operate until the vehicle is driven straight for a few seconds at 35 km/h (22 mph) or more.

   Result

   Proceed to
   OK
   NG

Result: 

OK 

END 

Result: 

NG 

See step  2

1. Clear the DTCs.

   Refer to DTC CHECK / CLEAR [03/2017 - 09/2018] , or refer to DTC CHECK / CLEAR [09/2018 - ]

   Chassis > ABS/VSC/TRAC > Clear DTCs 

2. Turn the engine switch off.
3. Turn the engine switch on (IG).
4. Check the DTCs (electronically controlled brake system) that are output.

   Refer to DTC CHECK / CLEAR [03/2017 - 09/2018] , or refer to DTC CHECK / CLEAR [09/2018 - ]

   Chassis > ABS/VSC/TRAC > Trouble Codes 

   Result

   Result	Proceed to
   DTCs are not output.	A
   Electronically controlled brake system DTCs are output.	B

Result: 

B 

REPAIR CIRCUITS INDICATED BY OUTPUT DTCS. Refer to  DIAGNOSTIC TROUBLE CODE CHART [03/2017 - 09/2018]  , or refer to  DIAGNOSTIC TROUBLE CODE CHART [09/2018 - 05/2023]  , or refer to  DIAGNOSTIC TROUBLE CODE CHART [05/2023 - ] 

Result: 

A 

See step  3

1. Check that the tire of each wheel is the correct size.

   Refer to INSPECTION [03/2017 - 05/2023] , or refer to INSPECTION [05/2023 - ]

   OK

   The tire of each wheel is the correct size.

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REPLACE THE TIRE OF EACH WHEEL WITH THE CORRECT SIZE 

Result: 

OK 

See step  4

1. Turn the engine switch off.
2. Check that the yaw rate sensor has been installed properly.

   Refer to INSTALLATION [03/2017 - 04/2020] , or refer to INSTALLATION [04/2020 - ]

   OK

   The yaw rate sensor is tightened to the specified torque.

   The yaw rate sensor is not tilted.

   Result

   Proceed to
   OK
   NG

Result: 

OK 

OBTAIN YAW RATE SENSOR ZERO POINT. Refer to  CALIBRATION [03/2017 - 05/2023]  , or refer to  CALIBRATION [05/2023 - ] 

Result: 

NG 

INSTALL YAW RATE SENSOR INSTALLATION. Refer to  REMOVAL [03/2017 - 04/2020]  , or refer to  REMOVAL [04/2020 - ]