DTC C1442-44: Invalid Data Received from Acceleration Sensor; DTC C1443-34: Invalid Data Received from Yaw Rate Sensor [03/2017 - 09/2018]: Procedure

1. Clear the DTCs.

   Refer to DTC CHECK / CLEAR [03/2017 - 09/2018]

   Chassis > ABS/VSC/TRAC > Clear DTCs 

2. Turn the engine switch off.
3. Turn the engine switch on (IG).
4. Check if the same DTC is output.

   Refer to DTC CHECK / CLEAR [03/2017 - 09/2018]

   Chassis > ABS/VSC/TRAC > Trouble Codes 

   Result

   Result	Proceed to
   DTCs C1442/44 and C1443/34 are not output.	A
   DTCs C1442/44 and/or C1443/34 are output.	B

Result: 

A 

USE SIMULATION METHOD TO CHECK. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [03/2017 - 04/2020] 

Result: 

B 

REPLACE YAW RATE SENSOR. Refer to  REMOVAL [03/2017 - 04/2020]