Inspection [03/2017 - ]: Procedure
- INSPECT LUGGAGE ELECTRICAL KEY SWITCH
- Check the resistance.
- Measure the resistance according to the value(s) in the table below.
*a Component without harness connected
(Luggage Electrical Key Switch)Standard Resistance
Tester Connection Condition Specified Condition 1 - 2 Luggage Electrical Key Switch OFF 10 kΩ or higher Luggage Electrical Key Switch ON Below 1 Ω If the result is not as specified, replace the luggage electrical key switch.
- Measure the resistance according to the value(s) in the table below.
- Check the resistance.