Removal [05/2023 - ]: Procedure

REMOVE FRONT SEAT ASSEMBLY LH
Refer to REMOVAL [05/2023 - ]
REMOVE REAR SEAT CUSHION ASSEMBLY
Refer to PROCEDURE - Step 1
REMOVE REAR SEAT CUSHION LOCK HOOK
Refer to PROCEDURE - Step 2
REMOVE REAR SEAT SIDE GARNISH
Refer to PROCEDURE - Step 3
REMOVE REAR SEATBACK COVER
Refer to PROCEDURE - Step 5
REMOVE REAR SEATBACK ASSEMBLY LH
Refer to PROCEDURE - Step 6
REMOVE QUARTER INSIDE TRIM BOARD LH
Refer to PROCEDURE - Step 18
REMOVE REAR NO. 1 SEAT INNER BELT ASSEMBLY LH
Refer to PROCEDURE - Step 4
REMOVE FRONT DOOR SCUFF PLATE LH
Refer to PROCEDURE - Step 10
REMOVE OUTER LAP BELT ANCHOR COVER
Refer to PROCEDURE - Step 11
REMOVE FRONT SEAT OUTER BELT ASSEMBLY LH (FLOOR ANCHOR)
Refer to PROCEDURE - Step 12
REMOVE QUARTER TRIM PANEL ASSEMBLY LH
Refer to PROCEDURE - Step 22

REMOVE FUEL LID WITH MOTOR LOCK ASSEMBLY

NOTE:

If the fuel lid lock control cable assembly has been struck or dropped, replace it with a new one.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Roll up it partially the room partition panel insulator.

Detach the cable lever from the hook fastener.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

*a	Cable Lever

Push the lever to detach the claw and remove the fuel lid lock with motor assembly from the fuel filler opening lid sub-assembly by pulling it out.

	Remove in this Direction
	Push the Lever