Caution / Notice / Hint
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front roof side rail weatherstrip removal/installation are shown below.
NECESSARY PROCEDURE AFTER PARTS REMOVED/INSTALLED/REPLACED
| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
| Disconnect cable from negative battery terminal | Memorize steering angle neutral point | Lane-keeping assist system | Refer to INITIALIZATION [03/2017 - 05/2023] |
| Pre-collision system | |||
| Parking assist monitor system | Refer to INITIALIZATION [03/2017 - 05/2023] | ||
| Steering sensor zero point calibration | Variable gear ratio steering system | Refer to INITIALIZATION [03/2017 - ] | |
| Front seat assembly RH (Only for removal and installation) | Zero point calibration (Occupant classification system) |
|
Refer to INITIALIZATION [03/2017 - ] |
HINT:
- Use the same procedure for both the RH and LH sides.
- The procedure described below is for the LH side.