LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2019 >> IS 350 Base, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 93 (Engine Lubrication System (2GR-FSE) - Service Information) >> Oil Pressure Switch >> Removal [04/2013 - 10/2017] >> Procedure

Removal [04/2013 - 10/2017]: Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2017 Lexus IS 350, 2017 Lexus IS 300, 2016 Lexus IS 350, 2016 Lexus IS 300, and 2015 Lexus IS 350. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE COOL AIR INTAKE DUCT SEAL 

    Refer to PROCEDURE - Step 1 [04/2013 - 10/2016] , or refer to PROCEDURE - Step 1 [10/2016 - 09/2020]

  2. REMOVE NO. 1 AIR CLEANER INLET 

    Refer to PROCEDURE - Step 20 [04/2013 - 08/2015] , or refer to PROCEDURE - Step 20 [08/2015 - 10/2016] , or refer to PROCEDURE - Step 19 [10/2016 - 10/2017]

  3. DRAIN ENGINE OIL 

    See step  1[04/2013 - 08/2015], or see step  1[08/2015 - 10/2017]

  4. REMOVE ENGINE OIL PRESSURE SWITCH ASSEMBLY 
    1. Disconnect the engine oil pressure switch assembly connector.
    2. Using a 24 mm deep socket wrench, remove the engine oil pressure switch assembly.
      GTY467474Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *A For 2WD
      *B For AWD
scientia non olet · About LEMON Manuals