LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2019 >> IS 350 Base, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 50 (Engine Lubrication System (8AR-FTS) - Service Information) >> Oil Pressure Sensor >> Removal [08/2015 - ] >> Procedure

Removal [08/2015 - ]: Procedure

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2024 Lexus IS 300, 2023 Lexus IS 300, 2022 Lexus IS 300, 2021 Lexus IS 300, and 2020 Lexus IS 300. However, it is still accessible from the selected car via links, so may be relevant.
  1. DISCONNECT NO. 4 VENTILATION HOSE 
    1. Slide the clip and disconnect the No. 4 ventilation hose from the inlet compressor elbow.
      GTY678851Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. REMOVE OIL PRESSURE SENDER GAUGE ASSEMBLY 
    1. Disconnect the oil pressure sender gauge assembly connector.
      GTY641322Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Using a 27 mm deep socket wrench, remove the oil pressure sender gauge assembly.
scientia non olet · About LEMON Manuals