LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2019 >> IS 350 Base, RWD >> Repair and Diagnosis >> Drivelines & Axles >> Axle Shafts >> Drive Shaft / Propeller Shaft - Service Information >> PROPELLER SHAFT ASSEMBLY (for 2GR 2WD) >> Removal [04/2013 - ] >> Procedure

Removal [04/2013 - ]: Procedure

  1. REMOVE ENGINE UNDER BRACE SUB-ASSEMBLY 
    1. Remove the 4 bolts and engine under brace sub-assembly.
      GTY460931Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. REMOVE FRONT EXHAUST PIPE ASSEMBLY (TWC: Rear Catalyst) 

    Refer to REMOVAL [04/2013 - 10/2016] , or refer to REMOVAL [10/2016 - 10/2017] , or refer to REMOVAL [10/2017 - 09/2020] , or refer to REMOVAL [09/2020 - ]

  3. REMOVE FRONT NO. 1 FLOOR HEAT INSULATOR 
    1. Remove the 4 nuts and front No. 1 floor heat insulator.
      GTY460965Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. REMOVE NO. 1 FUEL TANK PROTECTOR 
    1. Remove the 4 nuts and No. 1 fuel tank protector.
      GTY460967Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  5. REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY 
    1. Using SST, loosen the adjusting nut until it can be turned by hand.
      GTY461061Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Turn
      *b Hold
      • SST: 09922-10010 
      NOTE:

      Make sure to turn SST in the direction shown in the illustration.

      HINT: 

      Use 2 of the same type of SST.

    2. Put matchmarks on the automatic transmission flange yoke assembly and propeller with center bearing shaft assembly.
      GTY468802Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Matchmark
    3. Remove the 3 bolts, 3 washers and 3 nuts.
      NOTE:

      The propeller intermediate shaft assembly and flexible coupling should not be disconnected.

    4. Put matchmarks on the rear drive pinion companion flange and propeller with center bearing shaft assembly.
      GTY469266Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Matchmark
    5. Remove the 3 bolts, 3 washers and 3 nuts.
      NOTE:

      The propeller shaft assembly and flexible coupling should not be disconnected.

    6. Remove the 2 bolts and 2 adjusting washers.
      GTY460932Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      HINT: 

      Some vehicles are not equipped with the adjusting washers.

    7. Push the propeller shaft assembly straight forward to compress the propeller with center bearing shaft assembly and pull out the propeller with center bearing shaft assembly from the centering pin of the differential.
      GTY460934Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      NOTE:

      Press the propeller shaft assembly straight ahead to keep the transmission and propeller intermediate shaft assembly aligned straight.

      HINT: 

      If it is difficult to disconnect the flange from the flexible coupling, pry it using a screwdriver.

    8. Pull the propeller with center bearing shaft assembly outward from the vehicle's rear to remove it.
      NOTE:

      The propeller intermediate shaft assembly and propeller shaft assembly should not be disconnected.

scientia non olet · About LEMON Manuals