LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2019 >> GX 460 Base >> Repair and Diagnosis >> Engine Mechanical >> Starter >> Starting System (Service Information) >> Starter >> Installation [08/2015 - ] >> Procedure

Installation [08/2015 - ]: Procedure

  1. INSTALL FLYWHEEL HOUSING SIDE COVER 
  2. INSTALL STARTER ASSEMBLY 
    1. Install the starter with the 2 bolts.

      Torque: 37 N*m (377 kgf*cm, 27 ft.*lbf) 

    2. Connect the starter connector.
    3. Connect the starter wire with the nut.

      Torque: 9.8 N*m (100 kgf*cm, 87 in.*lbf) 

    4. Attach the starter wire clamp.
  3. INSTALL STARTER COVER 
    1. Install the starter cover with the 3 bolts.

      Torque: 12 N*m (117 kgf*cm, 8 ft.*lbf) 

  4. INSTALL EXHAUST MANIFOLD SUB-ASSEMBLY RH 

    (Refer to INSTALLATION [08/2015 - ] )

  5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Refer to INITIALIZATION [08/2015 - 08/2019] , or refer to INITIALIZATION [08/2019 - 08/2021] , or refer to INITIALIZATION [08/2021 - 08/2022] , or refer to INITIALIZATION [08/2022 - ] ).

scientia non olet · About LEMON Manuals