LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2019 >> GX 460 Base >> Repair and Diagnosis >> Electrical >> Gauges >> Meter / Gauge / Display (Service Information) >> Combination Meter >> Removal [08/2019 - ] >> Procedure

Removal [08/2019 - ]: Procedure

  1. DISABLE AUTOAWAY/RETURN FUNCTION 
    1. Disable the Autoaway/Return function by changing the customize parameter.

      Refer to CUSTOMIZE PARAMETERS [08/2019 - ]

      NOTE:

      Record the current customize parameter setting (whether the Autoaway/Return function is enabled or disabled) in order to restore the current setting after finishing the operation.

      HINT: 

      Performing the above operation causes the Autoaway/Return function to be disabled when the engine switch is turned off.

    2. Turn the engine switch on (IG). Operate the tilt and telescopic switch to fully extend and lower the steering column.
    3. Turn the engine switch off.
  2. PRECAUTION 
    NOTE:

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

    Refer to PRECAUTION [08/2015 - ]

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Refer to INITIALIZATION [08/2019 - 08/2021] , or refer to INITIALIZATION [08/2021 - 08/2022] , or refer to INITIALIZATION [08/2022 - ]

  4. REMOVE NO. 2 SWITCH HOLE BASE 

    Refer to PROCEDURE - Step 18 [08/2019 - 08/2021] , or refer to PROCEDURE - Step 18 [08/2021 - ]

  5. REMOVE NO. 1 INSTRUMENT PANEL FINISH CUSHION 

    Refer to PROCEDURE - Step 19 [08/2019 - 08/2021] , or refer to PROCEDURE - Step 19 [08/2021 - ]

  6. REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY 
    1. Place protective tape as shown in the illustration.
      GTY958905Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Protective Tape
    2. Detach the 4 claws.
    3. Detach the 2 clips.
      GTY278293Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Detach the 4 claws.
    5. Detach the guide and remove the instrument cluster finish panel sub-assembly.
  7. REMOVE NO. 1 INSTRUMENT PANEL REGISTER ASSEMBLY 

    Refer to PROCEDURE - Step 22 [08/2019 - 08/2021] , or refer to PROCEDURE - Step 28 [08/2021 - ]

  8. REMOVE COMBINATION METER ASSEMBLY 
    1. Remove the 2 screws.
      GTY958936Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Protective Tape
    2. Detach the 2 clips.
    3. Disconnect the connector and remove the combination meter assembly.
scientia non olet · About LEMON Manuals