LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2019 >> GX 460 Base >> Repair and Diagnosis >> Body & Frame >> Exterior/Interior Trim >> Exterior Panels / Trim (Service Information) >> Front Bumper >> Removal [08/2015 - 08/2019] >> Procedure

Removal [08/2015 - 08/2019]: Procedure

  1. PRECAUTION 
    NOTE:

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Refer to PRECAUTION [08/2015 - ] ).

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Refer to INITIALIZATION [08/2015 - 08/2019] ).

  3. REMOVE UPPER RADIATOR SUPPORT SEAL 
    1. Remove the 14 clips and upper radiator support seal.
      GTY462468Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. REMOVE FRONT BUMPER COVER 
    1. Remove the 2 screws labeled A and 2 screws labeled B.
      GTY645992Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      TEXT IN ILLUSTRATION

      *1 Screw A
      *2 Screw B
    2. Remove the 4 screws and 4 bolts.
      GTY654644Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      TEXT IN ILLUSTRATION

      *1 Screw
      *2 Bolt
    3. Remove the 4 screws.
      GTY462457Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      HINT: 

      Use the same procedure for the RH and LH sides.

    4. Put protective tape around the front bumper cover.
      GTY470277Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      TEXT IN ILLUSTRATION

      *1 Protective Tape
    5. Detach the 16 claws and remove the front bumper cover.
    6. w/ Intuitive Parking Assist System:

      Disconnect the connector.

    7. w/ Headlight Cleaner System:

      Disconnect the headlight cleaner hose.

    8. w/ Fog Light:

      Disconnect the 2 fog light connectors.

    9. Remove the front bumper cover.
  5. REMOVE FRONT BUMPER ENERGY ABSORBER 
    1. Remove the front bumper energy absorber.
      GTY462455Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  6. REMOVE FRONT BUMPER LOWER COVER 
    1. Remove the clip.
      GTY462456Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the 5 bolts and front bumper lower cover.
  7. REMOVE FRONT BUMPER REINFORCEMENT SUB-ASSEMBLY 
    1. Remove the 6 nuts and front bumper reinforcement sub-assembly.
      GTY462461Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  8. REMOVE FRONT BUMPER NO. 2 EXTENSION SUB-ASSEMBLY LH 
    1. Remove the 4 bolts and front bumper No. 2 extension sub-assembly LH.
      GTY462462Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  9. REMOVE FRONT BUMPER NO. 2 EXTENSION SUB-ASSEMBLY RH 

    HINT: 

    Use the same procedure described for the LH side.

  10. REMOVE HEADLIGHT ASSEMBLY LH 

    (Refer to REMOVAL [08/2015 - 08/2019] )

  11. REMOVE HEADLIGHT ASSEMBLY RH 

    HINT: 

    Use the same procedure described for the LH side.

  12. REMOVE FRONT BUMPER SIDE SUPPORT LH 
    1. Remove the screw.
      GTY469904Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Detach the 2 claws and remove the front bumper side support LH.
  13. REMOVE FRONT BUMPER SIDE SUPPORT RH 

    HINT: 

    Use the same procedure described for the LH side.

  14. REMOVE FRONT BUMPER LOWER NO. 2 RETAINER 
    1. Detach the 2 claws and remove the front bumper lower No. 2 retainer.
      GTY462458Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      HINT: 

      Use the same procedure for all front bumper lower No. 2 retainers.

  15. REMOVE FRONT BUMPER CENTER UPPER RETAINER 
    1. Remove the 4 bolts and front bumper center upper retainer.
      GTY469905Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  16. REMOVE RADIATOR SIDE DEFLECTOR LH 
    1. Detach the 3 claws and remove the radiator side deflector LH.
      GTY469903Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  17. REMOVE RADIATOR SIDE DEFLECTOR RH 

    HINT: 

    Use the same procedure described for the LH side.

  18. REMOVE FRONT BUMPER BRACKET SUB-ASSEMBLY LH 
    1. Remove the 2 bolts and front bumper bracket sub-assembly LH.
      GTY462453Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  19. REMOVE FRONT BUMPER BRACKET SUB-ASSEMBLY RH 

    HINT: 

    Use the same procedure described for the LH side.

scientia non olet · About LEMON Manuals