LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2019 >> GX 460 Base >> Repair and Diagnosis >> Accessories & Equipment >> Wiper/Washer Systems >> Wiper System / Washer System (Service Information) >> Rain Sensor >> Removal [08/2015 - ] >> Procedure

Removal [08/2015 - ]: Procedure

  1. REMOVE NO. 1 RAIN SENSOR COVER 
    1. Detach the 2 claws and remove the rain sensor cover.
      GTY284080Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. REMOVE RAIN SENSOR 
    1. Disconnect the connector.
      GTY613381Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Release the stopper by pulling it down.
      GTY284890Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      TEXT IN ILLUSTRATION

      *1 Stopper
    3. Remove the rain sensor as shown in the illustration.
  3. CLEAN WINDSHIELD GLASS 
    NOTE:
    • The rain sensor tape can be reused, however, replace it with a new piece of tape if it is dirty or damaged.
    • Check that the rain sensor tape does not remain on the windshield glass. If it does, remove it before installing the rain sensor.
scientia non olet · About LEMON Manuals