Installation [08/2015 - 08/2019]: Procedure

INSTALL COMBINATION METER ASSEMBLY
1. Connect the connector.
2. Attach the 2 clips.
3. Install the combination meter assembly with the 2 screws.
INSTALL NO. 1 INSTRUMENT PANEL REGISTER ASSEMBLY
Refer to PROCEDURE - Step 26
INSTALL INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY (w/o Driver Monitor Camera)
1. Attach the guide.
2. Attach the 4 claws.
3. Attach the 2 clips to install the instrument cluster finish panel sub-assembly.
4. Attach the 4 claws.
INSTALL INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY (w/ Driver Monitor Camera)
1. Attach the guide.
2. Attach the 4 claws.
3. Attach the 2 clips to install the instrument cluster finish panel sub-assembly.
INSTALL NO. 1 INSTRUMENT PANEL FINISH CUSHION
Refer to PROCEDURE - Step 29
INSTALL LOWER STEERING COLUMN COVER (w/ Driver Monitor Camera)
INSTALL UPPER STEERING COLUMN COVER (w/ Driver Monitor Camera)
INSTALL NO. 2 SWITCH HOLE BASE
Refer to PROCEDURE - Step 30
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Refer to INITIALIZATION [08/2015 - 08/2019] ).
RESTORE AUTOAWAY/RETURN FUNCTION
1. Restore the Autoaway/Return function setting to the previous condition by changing the customize parameter (Refer to CUSTOMIZE PARAMETERS [08/2015 - 08/2019] ).