LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2019 >> GS F >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission - Service Information >> Shift Lever >> Adjustment [10/2015 - ] >> Procedure

Adjustment [10/2015 - ]: Procedure

  1. REMOVE FRONT EXHAUST PIPE ASSEMBLY (TWC: Rear Catalyst) 

    Refer to REMOVAL [10/2015 - ]

  2. REMOVE FRONT NO. 1 FLOOR HEAT INSULATOR 

    Refer to PROCEDURE - Step 2

  3. ADJUST SHIFT LEVER POSITION 
    1. Move the shift lever to N.
    2. Remove the nut and disconnect the floor shift gear shifting rod sub-assembly from the lever of the transmission floor shift assembly.
      GTY621419Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Lever
    3. Turn the transmission control shaft lever RH counterclockwise until it stops, then turn it clockwise 2 notches.
      GTY462123Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *1 Transmission Control Shaft Lever RH
      *a P
      *b R
      *c N
    4. Connect the floor shift gear shifting rod sub-assembly to the lever of the transmission floor shift assembly.
      GTY651398Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Lever
      Push Toward Rear of Vehicle
    5. Temporarily install the nut to the lever of the transmission floor shift assembly.
    6. Tighten the nut while lightly pushing the lever of the transmission floor shift assembly toward the rear of the vehicle.

      Torque: 12.8 N*m (131 kgf*cm, 9 ft.*lbf) 

      NOTE:

      Do not push the lever of the transmission floor shift assembly too hard.

  4. INSTALL FRONT NO. 1 FLOOR HEAT INSULATOR 

    Refer to PROCEDURE - Step 5

  5. INSTALL FRONT EXHAUST PIPE ASSEMBLY (TWC: Rear Catalyst) 

    Refer to INSTALLATION [10/2015 - ]

  6. INSPECT SHIFT LEVER POSITION 

    See step  1

  7. INSPECT FOR EXHAUST GAS LEAK 

    Refer to PROCEDURE - Step 9

scientia non olet · About LEMON Manuals