Installation [10/2015 - ]: Procedure

1. Install the 2 rear stabilizer bushings to the outside of the stoppers on the rear stabilizer bar.
   NOTE:

   Be sure to install the rear stabilizer bushings so that each cutout faces the front of the vehicle.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Cutout
   *b	Stopper
   	Front of the Vehicle

2. Install the 2 rear No. 1 stabilizer bar brackets to the 2 rear stabilizer bushings.
   NOTE:

   Be sure to install the rear No. 1 stabilizer bar brackets so that each arrow mark faces the front of the vehicle.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Arrow Mark
   	Front of the Vehicle

3. Install the rear stabilizer bar sub-assembly and 2 rear No. 1 stabilizer bar brackets to the rear suspension member sub-assembly with the 4 bolts.

   Torque: 51 N*m (520 kgf*cm, 38 ft.*lbf) 

   NOTE:

   • Temporarily tighten the bolt (A), and then fully tighten the 4 bolts in the order of (B), (C), (D), and (A).
   • Ensure that the identification mark is on the right side of the vehicle.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Identification Mark

Refer to INSTALLATION [10/2015 - ] 

1. Install the rear stabilizer link assembly LH with the nut (B).

   Torque: 89 N*m (908 kgf*cm, 66 ft.*lbf) 

   HINT: 

   If the ball joint turns together with the nut, use a 6 mm hexagon socket wrench to hold the stud bolt.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Install the rear stabilizer link assembly LH with the nut (A).

   Torque: 15 N*m (153 kgf*cm, 11 ft.*lbf) 

HINT: 

Perform the same procedure as for the LH side.

Refer to PROCEDURE - Step 1

Refer to INITIALIZATION [10/2015 - ]

Refer to ADJUSTMENT [10/2015 - ]

Refer to TEST MODE PROCEDURE [10/2015 - 09/2017] , or Refer to TEST MODE PROCEDURE [09/2017 - ]

Refer to INITIALIZATION [10/2015 - ]

Refer to ADJUSTMENT [10/2015 - ]