Inspection [09/2014 - ]: Procedure
- INSPECT TRIP SWITCH
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Switch Condition Specified Condition 2 (A/B) - 5 (E) ODO TRIP switch on
(Pushed)Below 1 Ω 2 (A/B) - 5 (E) ODO TRIP switch off
(Not pushed)10 kΩ or higher If the result is not as specified, replace the trip switch.
TEXT IN ILLUSTRATION*1 ODO TRIP Switch *a Component without harness connected
(Trip Switch) Apply battery voltage to the connector and check the illumination condition.
OK
Measurement Condition Specified Condition Battery positive (+) → Terminal 8 (ILL+)
Battery negative (-) → Terminal 6 (ILL-)Illuminates If the result is not as specified, replace the trip switch.
TEXT IN ILLUSTRATION*a Component without harness connected
(Trip Switch)
- Measure the resistance according to the value(s) in the table below.