Caution / Notice / Hint

WARNING: This page is about a different car, the 2024 Lexus ES 250, 2023 Lexus ES 250, 2022 Lexus ES 250, and 2021 Lexus ES 250. However, it is still accessible from the selected car via links, so may be relevant.

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during fuel pump removal/installation are shown below.

NECESSARY PROCEDURES AFTER PARTS REMOVED/INSTALLED/REPLACED

Replaced Part or Performed Procedure	Necessary Procedure	Effect/Inoperative Function when Necessary Procedure not Performed	Link
Battery terminal is disconnected/reconnected	Perform steering sensor zero point calibration	Lane Control System (for Gasoline Model)	Refer to INITIALIZATION [06/2018 - 08/2021]
		Pre-collision System (for Gasoline Model)
		Parking Support Brake System (for Gasoline Model)*
		Lighting System (for Gasoline Model)
	Memorize steering angle neutral point	Parking Assist Monitor System (for Gasoline Model)	Refer to INITIALIZATION [06/2018 - 09/2022]
	Memorize steering angle neutral point	Panoramic View Monitor System (for Gasoline Model)	Refer to INITIALIZATION [06/2018 - 09/2022]
	Initialize power trunk lid system	Power Trunk Lid System (for Gasoline Model)	Refer to INITIALIZATION [06/2018 - ]
Replacement of fuel pump	Inspection after repair	Poor idle, etc. Engine start function, etc.	Refer to INITIALIZATION [08/2020 - ]

*: When performing learning using the Techstream.

WARNING:

Never perform work on fuel system components near any possible ignition sources.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Vaporized fuel could ignite, resulting in a serious accident.

Do not perform work on fuel system components without first disconnecting the cable from the negative (-) battery terminal.

Sparks could cause vaporized fuel to ignite, resulting in a serious accident.

NOTE:

After the engine switch is turned off, the radio receiver assembly records various types of memory and settings. As a result, after turning the engine switch off, make sure to wait at least 85 seconds before disconnecting the cable from the negative (-) battery terminal. (for Audio and Visual System)
After the engine switch is turned off, the radio receiver assembly records various types of memory and settings. As a result, after turning the engine switch off, make sure to wait at least 85 seconds before disconnecting the cable from the negative (-) battery terminal. (for Navigation System)