Installation [08/2020 - ]: Procedure
WARNING: This page is about a different car, the 2024 Lexus ES 250, 2023 Lexus ES 250, 2022 Lexus ES 250, and 2021 Lexus ES 250. However, it is still accessible from the selected car via links, so may be relevant.
- INSTALL FUEL PRESSURE SENSOR
HINT:
Perform "Inspection After Repair" after replacing the fuel pressure sensor.
Refer to INITIALIZATION [08/2020 - ]
- Temporarily install a new fuel pressure sensor to the fuel delivery pipe as shown in the illustration.
*a Cutout (Fuel Delivery Pipe) *b Cutout (Fuel Pressure Sensor) NOTE:Make sure that the cutout of the fuel delivery pipe is aligned with the cutout of the fuel pressure sensor.
- Temporarily install the No. 1 fuel pressure sensor holder to the fuel delivery pipe as shown in the illustration.
*a Cutout (Fuel Pressure Sensor) *b Cutout (No. 1 Fuel Pressure Sensor Holder) NOTE:Make sure that the cutout of the fuel pressure sensor is aligned with the cutout of the No. 1 fuel pressure sensor holder.
- Using an 8 mm socket wrench, install the 2 bolts.
Torque: 10 N.m (102 kgf/cm, 7 ft.lbf)
- Connect the fuel pressure sensor connector.
- Temporarily install a new fuel pressure sensor to the fuel delivery pipe as shown in the illustration.
- INSTALL INTAKE MANIFOLD
Refer to REMOVAL [08/2020 - 08/2021] , or refer to REMOVAL [08/2021 - ]
- CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Refer to PROCEDURE - Step 2
- INSPECT FOR FUEL LEAK
Refer to PROCEDURE - Step 1
- PERFORM INITIALIZATION
- Perform "Inspection After Repair" after replacing the fuel pressure sensor.
Refer to INITIALIZATION [08/2020 - ]
- Perform "Inspection After Repair" after replacing the fuel pressure sensor.