DTC B124B: Automatic High Beam System [08/2021 - ]: Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Lexus ES 300h, 2023 Lexus ES 300h, 2022 Lexus ES 300h, 2021 Lexus ES 300h, and 2020 Lexus ES 300h. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK FOR DTC (HEALTH CHECK)
- Connect the Techstream to the DLC3.
- Turn the power switch on (IG).
- Turn the Techstream on.
- Enter the following menus: System Select / Health Check.
- Check for DTCs.
Result
Result Proceed to Only DTC B124B is output A DTC B124B and other DTCs are output B
Result:
B
GO TO OTHER DTC CHART
Result:
A
See step 2
- CHECK FRONT CAMERA SYSTEM
- Check if a dynamic radar cruise control system, lane tracing assist system, road sign assist system* or pre-collision system warning message is displayed on the multi-information display.
Refer to DIAGNOSIS SYSTEM [08/2021 - ]
OK
No dynamic radar cruise control system, lane tracing assist system, road sign assist system* or pre-collision system warning messages are displayed.
- *: w/ Road Sign Assist System
Result
Proceed to OK NG
Result:
OK
REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU). Refer to REMOVAL [08/2021 - 09/2022] , or refer to REMOVAL [09/2022 - ]
Result:
NG
GO TO FRONT CAMERA SYSTEM. Refer to PROBLEM SYMPTOMS TABLE [08/2021 - ]
- Check if a dynamic radar cruise control system, lane tracing assist system, road sign assist system* or pre-collision system warning message is displayed on the multi-information display.