LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2019 >> ES 350 Luxury >> Repair and Diagnosis >> External Pages >> Different car >> Section 79 (Automatic Transmission System (UB80F) - Service Information (2 Of 2)) >> Oil Pump >> Reassembly [08/2020 - ] >> Procedure

Reassembly [08/2020 - ]: Procedure

WARNING: This page is about a different car, the 2024 Lexus ES 250, 2023 Lexus ES 250, 2022 Lexus ES 250, and 2021 Lexus ES 250. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL RING PIN 
    1. Install the 2 ring pins to the front oil pump cover sub-assembly.
      GTY733622Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL FRONT OIL PUMP BODY 
    1. Install the front oil pump body to the front oil pump cover sub-assembly.
      GTY698820Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. INSTALL FRONT OIL PUMP DRIVEN GEAR 
    1. Coat the front oil pump driven gear with Toyota Genuine ATF WS and install it to the front oil pump body.
      GTY698818Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. INSTALL FRONT OIL PUMP DRIVE GEAR 
    GTY698819Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Coat the front oil pump drive gear with Toyota Genuine ATF WS and install it to the front oil pump body.
  5. INSTALL STATOR SHAFT ASSEMBLY 
    1. Install the stator shaft assembly to the front oil pump body with the 5 bolts.
      GTY717015Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Torque: 9.1 N*m (93 kgf*cm, 81 in.*lbf) 

      Bolt Length

      Bolt (A) Bolt (B)
      50 mm (1.97 in.) 45 mm (1.77 in.)
  6. INSTALL OIL STRAINER ASSEMBLY 
    1. Using a T30 "TORX" socket wrench, install a new oil strainer assembly to the front oil pump cover sub-assembly with the 2 "TORX" bolts.
      GTY741081Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf) 

  7. INSTALL CLUTCH DRUM OIL SEAL RING 
    1. Apply a small amount of MP grease to the entire circumference of the clutch drum oil seal ring installation groove portion.

      HINT: 

      By applying MP grease, the wobble within the clutch drum oil seal ring installation groove will be eliminated, preventing damage to the clutch drum oil seal ring at the time of front oil pump assembly installation.

    2. Coat 4 new clutch drum oil seal rings with Toyota Genuine ATF WS and install them to the stator shaft assembly.
      NOTE:

      While making the spread of the opening of the clutch drum oil seal ring as small as possible, install it to the stator shaft assembly.

      If the ring opening is spread, briefly hold it closed with your fingers to return it to its original condition.

      GTY768678Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals