DTC P2614-01: Camshaft Position Signal Output "A" General Electrical Failure [08/2020 - 08/2021]: Procedure
WARNING: This page is about a different car, the 2024 Lexus ES 250, 2023 Lexus ES 250, 2022 Lexus ES 250, and 2021 Lexus ES 250. However, it is still accessible from the selected car via links, so may be relevant.
- REPLACE CAM TIMING CONTROL MOTOR WITH EDU ASSEMBLY
- Replace the cam timing control motor with EDU assembly.
Refer to REMOVAL [08/2020 - 08/2021]
HINT:
Perform "Inspection After Repair" after replacing the cam timing control motor with EDU assembly.
Refer to INITIALIZATION [08/2020 - ]
Result
Proceed to NEXT
Result:
NEXT
See step 2
- Replace the cam timing control motor with EDU assembly.
- CLEAR DTC
- Connect the Techstream to the DLC3.
- Turn the engine switch on (IG).
- Turn the Techstream on.
- Clear the DTCs.
Powertrain > Engine > Clear DTCs
- Turn the engine switch off and wait for at least 30 seconds.
Result
Proceed to NEXT
Result:
NEXT
See step 3
- CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED
- Drive the vehicle in accordance with the driving pattern described in the Confirmation Driving Pattern.
- Enter the following menus: Powertrain / Engine / Trouble Codes.
- Read the DTCs.
Powertrain > Engine > Trouble Codes
Result
Result Proceed to DTCs are not output A DTC P2614-01 is output B
Result:
A
END
Result:
B
REPLACE ECM. Refer to REMOVAL [08/2020 - 08/2021]