LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2019 >> ES 350 Luxury >> Repair and Diagnosis >> External Pages >> Different car >> Section 77 (Automatic Transmission System (UB80F) - Service Information (1 Of 2)) >> Combination Switch >> Inspection [08/2020 - ] >> Procedure

Inspection [08/2020 - ]: Procedure

WARNING: This page is about a different car, the 2024 Lexus ES 250, 2023 Lexus ES 250, 2022 Lexus ES 250, and 2021 Lexus ES 250. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSPECT DRIVE MODE SELECT SWITCH (COMBINATION SWITCH ASSEMBLY) 
    1. Inspect the "Normal" mode switch:
      1. Measure the resistance according to the value(s) in the table below.
        GTY826695Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
        *a Component without harness connected
        (Drive Mode Select Switch (Combination Switch Assembly))

        Standard Resistance

        Tester Connection Condition Specified Condition
        2 (B) - 7 (GND) "Normal" mode switch being pushed and held Below 1 Ω
        "Normal" mode switch not pushed 10 kΩ or higher

        If the result is not as specified, replace the drive mode select switch (combination switch assembly).

    2. Inspect the "Sport" mode switch:
      1. Measure the resistance according to the value(s) in the table below.
        GTY826691Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
        *a Component without harness connected
        (Drive Mode Select Switch (Combination Switch Assembly))

        Standard Resistance

        Tester Connection Condition Specified Condition
        3 (P) - 7 (GND) Combination switch assembly knob turned and held at "Sport" position Below 1 Ω
        Combination switch assembly knob not turned to "Sport" position 10 kΩ or higher

        If the result is not as specified, replace the drive mode select switch (combination switch assembly).

    3. Inspect the "Eco" mode switch:
      1. Measure the resistance according to the value(s) in the table below.
        GTY826690Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
        *a Component without harness connected
        (Drive Mode Select Switch (Combination Switch Assembly))

        Standard Resistance

        Tester Connection Condition Specified Condition
        6 (ECU) - 7 (GND) Combination switch assembly knob turned and held at "Eco" position Below 1 Ω
        Combination switch assembly knob not turned to "Eco" position 10 kΩ or higher

        If the result is not as specified, replace the drive mode select switch (combination switch assembly).

    4. Inspect the illumination:
      1. Apply battery voltage to the drive mode select switch (combination switch assembly) and check that the switch illuminates.
        GTY826689Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
        *a Component without harness connected
        (Drive Mode Select Switch (Combination Switch Assembly))

        OK

        Condition Specified Condition
        Battery positive (+) → Terminal 1 (ILL+)
        Battery negative (-) → Terminal 8 (ILL-)        		 Illuminates

        If the result is not as specified, replace the drive mode select switch (combination switch assembly).

scientia non olet · About LEMON Manuals