LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2019 >> ES 350 Luxury >> Repair and Diagnosis >> External Pages >> Different car >> Section 77 (Automatic Transmission System (UB80F) - Service Information (1 Of 2)) >> Automatic Transaxle Fluid >> Replacement [08/2020 - ] >> Procedure

Replacement [08/2020 - ]: Procedure

WARNING: This page is about a different car, the 2024 Lexus ES 250, 2023 Lexus ES 250, 2022 Lexus ES 250, and 2021 Lexus ES 250. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE FRONT WHEEL OPENING EXTENSION PAD RH 

    Refer to PROCEDURE - Step 9 [08/2020 - 08/2021] , or refer to PROCEDURE - Step 9 [08/2021 - 09/2022] , or refer to PROCEDURE - Step 9 [09/2022 - ]

  2. REMOVE FRONT WHEEL OPENING EXTENSION PAD LH 

    Refer to PROCEDURE - Step 8 [08/2020 - 08/2021] , or refer to PROCEDURE - Step 8 [08/2021 - 09/2022] , or refer to PROCEDURE - Step 8 [09/2022 - ]

  3. REMOVE NO. 1 ENGINE UNDER COVER 

    Refer to PROCEDURE - Step 10 [08/2020 - 08/2021] , or refer to PROCEDURE - Step 10 [08/2021 - 09/2022] , or refer to PROCEDURE - Step 10 [09/2022 - ]

  4. REMOVE NO. 2 ENGINE UNDER COVER ASSEMBLY 

    Refer to PROCEDURE - Step 11 [08/2020 - 08/2021] , or refer to PROCEDURE - Step 11 [08/2021 - 09/2022] , or refer to PROCEDURE - Step 11 [09/2022 - ]

  5. REMOVE FRONT FENDER APRON SEAL LH 

    Refer to PROCEDURE - Step 12 [08/2020 - 08/2021] , or refer to PROCEDURE - Step 12 , or refer to PROCEDURE - Step 12 [09/2022 - ]

  6. REPLACE AUTOMATIC TRANSAXLE FLUID 

    Refer to PROCEDURE - Step 6

  7. ADD SPECIFIED AMOUNT OF AUTOMATIC TRANSAXLE FLUID 

    See step  5

  8. ADJUST AUTOMATIC TRANSAXLE FLUID TEMPERATURE (when Using the Techstream) 

    See step  6

  9. ADJUST AUTOMATIC TRANSAXLE FLUID TEMPERATURE (when Not Using the Techstream) 

    See step  7

  10. ADJUST AUTOMATIC TRANSAXLE FLUID LEVEL 

    See step  8

  11. PERFORM ATF THERMAL DEGRADATION ESTIMATE RESET 
    NOTE:

    If approximately 50% or more of the ATF has been replaced during a repair of the transaxle or a similar operation, perform ATF Thermal Degradation Estimate Reset.

    Refer to INITIALIZATION [08/2020 - ]

  12. REBUILD WORK 

    See step  10

  13. INSTALL FRONT FENDER APRON SEAL LH 

    Refer to PROCEDURE - Step 69 [08/2020 - 08/2021] , or refer to PROCEDURE - Step 70 [08/2021 - ]

  14. INSTALL NO. 2 ENGINE UNDER COVER ASSEMBLY 

    Refer to PROCEDURE - Step 71 [08/2020 - 08/2021] , or refer to PROCEDURE - Step 72 [08/2021 - ]

  15. INSTALL NO. 1 ENGINE UNDER COVER 

    Refer to PROCEDURE - Step 72 [08/2020 - 08/2021] , or refer to PROCEDURE - Step 73 [08/2021 - ]

  16. INSTALL FRONT WHEEL OPENING EXTENSION PAD LH 

    Refer to PROCEDURE - Step 73 [08/2020 - 08/2021] , or refer to PROCEDURE - Step 74 [08/2021 - ]

  17. INSTALL FRONT WHEEL OPENING EXTENSION PAD RH 

    Refer to PROCEDURE - Step 74 [08/2020 - 08/2021] , or refer to PROCEDURE - Step 75 [08/2021 - ]

scientia non olet · About LEMON Manuals