Adjustment [06/2018 - 01/2020]: Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Lexus ES 300h, 2023 Lexus ES 300h, 2022 Lexus ES 300h, 2021 Lexus ES 300h, and 2020 Lexus ES 300h. However, it is still accessible from the selected car via links, so may be relevant.

SECURE VEHICLE

Fully apply the parking brake and chock a wheel.

WARNING:

Make sure to apply the parking brake and chock a wheel before performing this procedure.
If the vehicle is not secure and the shift lever is moved to N, the vehicle may suddenly move, possibly resulting in an accident or serious injury.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

REMOVE CONSOLE BOX ASSEMBLY
Refer to REMOVAL [06/2018 - 08/2020]

ADJUST SHIFT LEVER POSITION

NOTE:

Before adjusting the transmission control cable assembly, check that the shift lever position sensor and shift lever are in N.

Disconnect the transmission control cable assembly from the transmission floor shift assembly.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Slide the slider of the transmission control cable assembly in the direction indicated by the arrow in the illustration and pull the lock piece outward.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

*a	Slider
*b	Lock Piece
*c	Slide
*d	Pull

Connect the transmission control cable assembly to the transmission floor shift assembly.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

*a	Lock Piece
*b	Adjuster Case

NOTE:

Check that the lock piece is pulled out.
Push the end of the transmission control cable assembly all the way to the base of the transmission floor shift assembly pin.
Connect the transmission control cable assembly so that the lock piece faces the driver side.

Push the lock piece into the adjuster case.

*a	Lock Piece
*b	Push in
*c	Adjuster Case

NOTE:

Check that the shift lever position sensor and shift lever are in N.
Securely push in the lock piece until the slider lock is engaged.

When pushing in the lock piece of the adjuster case to lock it, remove your hand from the lever shaft.

*1	Transmission Control Cable Assembly
*a	Lever Shaft

When pushing in the lock piece of the adjuster case to lock it, do not move the lever shaft or transmission control cable assembly forward or backward.

After adjusting the shift lever position, check the position and operation of the shift lever. If there is a problem, adjust the shift lever position again.

INSTALL CONSOLE BOX ASSEMBLY
Refer to INSTALLATION [06/2018 - 08/2020]