LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2019 >> ES 350 Luxury >> Repair and Diagnosis >> External Pages >> Different car >> Section 71 (Hybrid Transaxle System (P710) - Service Information) >> Shift Lever >> Removal [06/2018 - 09/2022] >> Procedure

Removal [06/2018 - 09/2022]: Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Lexus ES 300h, 2023 Lexus ES 300h, 2022 Lexus ES 300h, 2021 Lexus ES 300h, and 2020 Lexus ES 300h. However, it is still accessible from the selected car via links, so may be relevant.
  1. SECURE VEHICLE 
    1. Fully apply the parking brake and chock a wheel.
      WARNING:
      • Make sure to apply the parking brake and chock a wheel before performing this procedure.
      • If the vehicle is not secure and the shift lever is moved to N, the vehicle may suddenly move, possibly resulting in an accident or serious injury.
      GTY655852Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. REMOVE SHIFT LOCK RELEASE BUTTON COVER 
    1. Apply protective tape to the upper console panel sub-assembly at the location shown in the illustration.
      GTY815640Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Protective Tape
    2. Using a screwdriver with its tip wrapped with protective tape, disengage the 2 claws and guide to remove the shift lock release button cover from the upper console panel sub-assembly.
      NOTE:

      Be careful not to damage the shift lock release button cover and upper console panel sub-assembly.

  3. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY 

    See step  1

  4. REMOVE CONSOLE BOX ASSEMBLY 

    Refer to REMOVAL [06/2018 - 08/2020] , or refer to REMOVAL [08/2020 - 09/2022]

  5. DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY 
    NOTE:

    Before disconnecting the transmission control cable assembly, check that the shift lever is in N.

    1. Disconnect the transmission control cable assembly from the transmission floor shift assembly.
      GTY834844Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Rotate the lock nut counterclockwise approximately 180° and, while holding the lock nut in that position, disconnect the transmission control cable assembly from the transmission floor shift assembly.
      GTY776743Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Counterclockwise
  6. REMOVE TRANSMISSION FLOOR SHIFT ASSEMBLY 
    1. Remove the 4 bolts.
      GTY809686Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the clip to disconnect the No. 1 console box duct from the transmission floor shift assembly.
      GTY809696Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Disconnect the transmission control switch connector.
      GTY834846Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Disengage the clamp to disconnect the wire harness from the transmission floor shift assembly.
    5. Disconnect the shift lock control ECU connector.
      GTY809693Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    6. Disengage the clamp to disconnect the wire harness from the transmission floor shift assembly.
    7. Remove the transmission floor shift assembly.
scientia non olet · About LEMON Manuals