LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2019 >> ES 350 Luxury >> Repair and Diagnosis >> External Pages >> Different car >> Section 64 (Fuel System (A25A-FXS) - Service Information) >> Fuel Sender Gauge Assembly >> Installation [06/2018 - ] >> Procedure

Installation [06/2018 - ]: Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Lexus ES 300h, 2023 Lexus ES 300h, 2022 Lexus ES 300h, 2021 Lexus ES 300h, and 2020 Lexus ES 300h. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL FUEL SENDER GAUGE ASSEMBLY 
    1. for Type A:
      1. Engage the claw to install the fuel sender gauge assembly to the fuel suction tube with pump and gauge assembly.
        NOTE:

        Be careful not to bend the arm of the fuel sender gauge assembly.

      2. Engage the 2 clamps to connect the wire harness to the fuel suction tube with pump and gauge assembly.
        NOTE:
        • Do not damage the wire harness.
        • When engaging each wire harness to the clamp, engage one wire at a time.
      3. Connect the fuel sender gauge assembly connector.
    2. for Type B:
      1. Engage the 2 claws to install the fuel sender gauge assembly to the fuel gauge bracket.
      2. Engage the 2 claws to install the fuel gauge bracket with fuel sender gauge assembly to the fuel suction tube with pump and gauge assembly.
        NOTE:

        Be careful not to bend the arm of the fuel sender gauge assembly.

      3. Engage the 2 clamps to connect the wire harness to the fuel suction tube with pump and gauge assembly.
        NOTE:
        • Do not damage the wire harness.
        • When engaging each wire harness to the clamp, engage one wire at a time.
      4. Connect the fuel sender gauge assembly connector.
  2. INSTALL FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY 

    Refer to INSTALLATION [06/2018 - ] 

scientia non olet · About LEMON Manuals