Installation [06/2018 - ]: Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Lexus ES 300h, 2023 Lexus ES 300h, 2022 Lexus ES 300h, 2021 Lexus ES 300h, and 2020 Lexus ES 300h. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL FUEL MAIN VALVE ASSEMBLY

for Type A:
1. Apply gasoline to 2 new O-rings. Then install the O-rings to the fuel main valve assembly.
2. Install the fuel main valve assembly to the fuel suction tube with pump and gauge assembly.
  NOTE:
  Make sure that the O-rings are not cut or pinched during installation.
3. Install the clip to the fuel suction tube with pump and gauge assembly.

for Type B:

Apply gasoline to a new O-ring. Then install the O-ring to the fuel main valve assembly.

NOTE:

Make sure that there is no clearance between the fuel main valve assembly and mesh.

*1	Fuel Main Valve Assembly
*a	Mesh
*b	Mini-clip
*c	No Clearance

Install the fuel main valve assembly to the fuel suction tube with pump and gauge assembly.
NOTE:
Make sure that the O-ring is not cut or pinched during installation.
Engage the 2 claws to install the fuel pressure regulator holder to the fuel suction tube with pump and gauge assembly.

INSTALL FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY
Refer to INSTALLATION [06/2018 - ]