On-Vehicle Inspection [06/2018 - ]: Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Lexus ES 300h, 2023 Lexus ES 300h, 2022 Lexus ES 300h, 2021 Lexus ES 300h, and 2020 Lexus ES 300h. However, it is still accessible from the selected car via links, so may be relevant.

FUEL PUMP ASSEMBLY OPERATION

Check fuel pressure.

Connect the Techstream to the DLC3.
Turn the power switch on (IG).
Turn the Techstream on.

Put the engine in Inspection Mode (Maintenance Mode).

Powertrain > Hybrid Control > Utility

Tester Display
Inspection Mode

Start the engine.

Enter the following menus: Powertrain / Engine / Active Test / Control the Target Fuel Pressure Offset.

Powertrain > Engine > Active Test

Active Test Display
Control the Target Fuel Pressure Offset

Data List Display
Fuel Pressure (High)

Select the Data List item: Fuel Pressure (High).
Check that the fuel pressure fluctuates when the target fuel pressure changes.
HINT:

The target fuel pressure operation decreases the target fuel pressure by 12.5% or increases the target fuel pressure by 24.8%.

If the result is not as specified, replace the fuel pump assembly or fuel delivery pipe.

Check operating sound.
1. Remove the No. 1 engine cover sub-assembly.
  Refer to PROCEDURE - Step 18 [06/2018 - 08/2020] , or refer to PROCEDURE - Step 18 [08/2020 - 08/2021] , or refer to PROCEDURE - Step 18 [08/2021 - 09/2022] , or refer to PROCEDURE - Step 18 [09/2022 - ]
2. Start the engine.
3. Using a sound scope, check the operating sound of the fuel pump assembly.
  If no sound can be heard, check the fuel pump assembly, wire harness and ECM.
4. Stop the engine.
5. Install the No. 1 engine cover sub-assembly.
  Refer to PROCEDURE - Step 46 [06/2018 - 08/2021] , or refer to PROCEDURE - Step 47 [08/2021 - ]