LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2019 >> ES 350 Luxury >> Repair and Diagnosis >> External Pages >> Different car >> Section 62 (Engine Cooling System (A25A-FXS) - Inspection) >> Cooling System >> On-Vehicle Inspection [06/2018 - ] >> Procedure

On-Vehicle Inspection [06/2018 - ]: Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Lexus ES 300h, 2023 Lexus ES 300h, 2022 Lexus ES 300h, 2021 Lexus ES 300h, and 2020 Lexus ES 300h. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSPECT FOR COOLANT LEAK (for Engine) 
    WARNING:

    Do not remove the radiator cap sub-assembly while the engine and radiator assembly are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

    1. Remove the radiator cap sub-assembly.
    2. Fill the radiator assembly with engine coolant, and then install a radiator cap tester.
      GTY771229Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Radiator Cap Tester
    3. Put the engine in Inspection Mode (Maintenance Mode).
      1. Connect the Techstream to the DLC3.
      2. Turn the power switch on (IG).
      3. Turn the Techstream on.
      4. Enter following menus: Powertrain / Hybrid Control / Utility / Inspection Mode.

        Powertrain > Hybrid Control > Utility 

        Tester Display
        Inspection Mode
    4. Warm up the engine.
    5. Pump the radiator cap tester to 103 kPa (1.1 kgf/cm2 , 15 psi), and then check that the pressure does not drop.
      • If the pressure drops, check the hoses, radiator assembly and engine water pump assembly (water inlet housing) for leaks.
      • If there are no signs of external engine coolant leaks, check the heater core, cylinder block sub-assembly and cylinder head sub-assembly.
    6. Remove the radiator cap tester.
    7. Install the radiator cap sub-assembly.
  2. INSPECT ENGINE COOLANT LEVEL IN RESERVOIR TANK (for Engine) 
    1. Check that the engine coolant level is between the L line and F line when the engine is cold.
      GTY746996Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a F Line
      *b L Line

      If the engine coolant level is low, check for leaks and add engine coolant to the F line.

      NOTE:

      Do not substitute plain water for engine coolant.

  3. INSPECT ENGINE COOLANT QUALITY (for Engine) 
    WARNING:

    Do not remove the radiator cap sub-assembly while the engine and radiator assembly are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

    1. Remove the radiator cap sub-assembly.
    2. Check if there are any excessive deposits of rust or scale around the radiator cap sub-assembly and water filler hole. Also, the engine coolant should be free of oil.

      If excessively dirty, replace the engine coolant.

    3. Install the radiator cap sub-assembly.
scientia non olet · About LEMON Manuals