Installation [08/2021 - ]: Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Lexus ES 300h, 2023 Lexus ES 300h, 2022 Lexus ES 300h, 2021 Lexus ES 300h, and 2020 Lexus ES 300h. However, it is still accessible from the selected car via links, so may be relevant.
- SET EGR VALVE ASSEMBLY
- Set the EGR valve assembly to the camshaft housing.
HINT:
At this time, do not install the parts with bolts.
- Install the No. 4 water by-pass hose to the EGR valve assembly and slide the clip to secure it.
- Connect the No. 8 water by-pass hose to the EGR valve assembly and slide the clip to secure it.
- Set the EGR valve assembly to the camshaft housing.
- INSTALL EGR COOLER ASSEMBLY
Refer to INSTALLATION [08/2021 - ]
- INSTALL EGR VALVE ASSEMBLY
- Using an 8 mm socket wrench, install the EGR valve assembly to the camshaft housing with the 2 bolts.
Torque: 10 N.m (102 kgf/cm, 7 ft.lbf)
- Using an 8 mm socket wrench, install the EGR valve assembly to the camshaft housing with the 2 bolts.
- INSTALL NO. 1 EGR PIPE SUB-ASSEMBLY
- Install a new EGR inlet gasket to the intake manifold.
- Install a new EGR valve adapter gasket to the No. 1 EGR pipe sub-assembly.
- Using an 8 mm socket wrench, install the No. 1 EGR pipe sub-assembly to the intake manifold and EGR valve assembly with the 4 bolts.
Torque: 10 N.m (102 kgf/cm, 7 ft.lbf)
- CONNECT ENGINE WIRE
- Engage the 2 wire harness clamps to connect the engine wire.
- Install the bolt.
Torque: 10 N.m (102 kgf/cm, 7 ft.lbf)
- Connect the EGR valve assembly connector.
- Engage the 3 hose clamps to connect the No. 1 fuel vapor feed hose and No. 2 fuel vapor feed hose.
*1 No. 1 Fuel Vapor Feed Hose *2 No. 2 Fuel Vapor Feed Hose