DTC B1ACB-71: Front Left Speaker Cable Actuator Stuck [09/2022 - ]: Procedure
- CHECK PROBLEM SYMPTOM
- Confirm the problem symptoms and proceed to the respective link.
Result
Result Proceed to No sound is output from the front No. 1 speaker assembly LH A No sound is output from the front No. 2 speaker assembly LH B No sound is output from the front No. 4 speaker assembly LH
(w/ "Mark Levinson" sound system)C
Result:
B
See step 5
Result:
C
See step 8
Result:
A
See step 2
- Confirm the problem symptoms and proceed to the respective link.
- CHECK HARNESS AND CONNECTOR (STEREO COMPONENT AMPLIFIER ASSEMBLY - FRONT NO. 1 SPEAKER ASSEMBLY LH)
- Disconnect the G11 stereo component amplifier assembly connector.
- Disconnect the J19 front No. 1 speaker assembly LH connector.
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition G11-4 (WFL+) - J19-2 (WF+) Always Below 1 Ω G11-19 (WFL-) - J19-1 (WF-) Always Below 1 Ω Result
Proceed to OK NG
Result:
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
Result:
OK
See step 3
- INSPECT FRONT NO. 1 SPEAKER ASSEMBLY LH
Refer to INSPECTION [06/2018 - ]
Result
Proceed to OK NG Result:
NG
REPLACE FRONT NO. 1 SPEAKER ASSEMBLY LH. Refer to REMOVAL [06/2018 - ]
Result:
OK
See step 4
- CHECK FOR DTC
- Clear the DTCs.
Body Electrical > Navigation System > Clear DTCs
- In accordance with the display of the GTS, perform a speaker circuit energization inspection.
Refer to UTILITY [09/2022 - ]
Body Electrical > Navigation System > Utility
Tester Display Speaker Line Electricity Check - Check for DTCs and proceed to the following step.
Body Electrical > Navigation System > Trouble Codes
Result
Result Proceed to DTCs are not output A DTC B1ACB-71 is output B
Result:
A
END (FRONT NO. 1 SPEAKER ASSEMBLY LH IS DEFECTIVE)
Result:
B
REPLACE STEREO COMPONENT AMPLIFIER ASSEMBLY. Refer to REMOVAL [09/2022 - ]
- Clear the DTCs.
- CHECK HARNESS AND CONNECTOR (STEREO COMPONENT AMPLIFIER ASSEMBLY - FRONT NO. 2 SPEAKER ASSEMBLY LH)
- Disconnect the G11 stereo component amplifier assembly connector.
- Disconnect the G79 front No. 2 speaker assembly LH connector.
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition G11-12(FL+) - G79-2(+) Always Below 1 Ω G11-27(FL-) - G79-1 (-) Always Below 1 Ω Result
Proceed to OK NG
Result:
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
Result:
OK
See step 6
- REPLACE FRONT NO. 2 SPEAKER ASSEMBLY LH
- Replace the front No. 2 speaker assembly LH with a new or known good one.
Refer to REMOVAL [08/2021 - ]
Result
Proceed to NEXT
Result:
NEXT
See step 7
- Replace the front No. 2 speaker assembly LH with a new or known good one.
- CHECK FOR DTC
- Clear the DTCs.
Body Electrical > Navigation System > Clear DTCs
- In accordance with the display of the GTS, perform a speaker circuit energization inspection.
Refer to UTILITY [09/2022 - ]
Body Electrical > Navigation System > Utility
Tester Display Speaker Line Electricity Check - Check for DTCs and proceed to the following step.
Body Electrical > Navigation System > Trouble Codes
Result
Result Proceed to DTCs are not output A DTC B1ACB-71 is output B
Result:
A
END (FRONT NO. 2 SPEAKER ASSEMBLY LH IS DEFECTIVE)
Result:
B
REPLACE STEREO COMPONENT AMPLIFIER ASSEMBLY. Refer to REMOVAL [09/2022 - ]
- Clear the DTCs.
- CHECK HARNESS AND CONNECTOR (STEREO COMPONENT AMPLIFIER ASSEMBLY - FRONT NO. 4 SPEAKER ASSEMBLY LH)
- Disconnect the G11 stereo component amplifier assembly connector.
- Disconnect the J18 front No. 4 speaker assembly LH connector.
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition G11-10 (TWL+) - J18-2 (+) Always Below 1 Ω G11-25 (TWL-) - J18-1 (-) Always Below 1 Ω Result
Proceed to OK NG
Result:
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
Result:
OK
See step 9
- REPLACE FRONT NO. 4 SPEAKER ASSEMBLY LH
- Replace the front No. 4 speaker assembly LH with a new or known good one.
Refer to REMOVAL [06/2018 - ]
Result
Proceed to NEXT
Result:
NEXT
See step 10
- Replace the front No. 4 speaker assembly LH with a new or known good one.
- CHECK FOR DTC
- Clear the DTCs.
Body Electrical > Navigation System > Clear DTCs
- In accordance with the display of the GTS, perform a speaker circuit energization inspection.
Refer to UTILITY [09/2022 - ]
Body Electrical > Navigation System > Utility
Tester Display Speaker Line Electricity Check - Check for DTCs and proceed to the following step.
Body Electrical > Navigation System > Trouble Codes
Result
Result Proceed to DTCs are not output A DTC B1ACB-71 is output B
Result:
A
END (FRONT NO. 4 SPEAKER ASSEMBLY LH IS DEFECTIVE)
Result:
B
REPLACE STEREO COMPONENT AMPLIFIER ASSEMBLY. Refer to REMOVAL [09/2022 - ]
- Clear the DTCs.