Installation [08/2020 - ]: Procedure
WARNING: This page is about a different car, the 2024 Lexus ES 250, 2023 Lexus ES 250, 2022 Lexus ES 250, and 2021 Lexus ES 250. However, it is still accessible from the selected car via links, so may be relevant.
- INSTALL STARTER ASSEMBLY
- Install the starter assembly to the cylinder block sub-assembly with the 2 bolts.
Torque: 46 N.m (469 kgf/cm, 34 ft.lbf)
- Connect the No. 2 engine wire to terminal 30 with the nut.
Torque: 9.8 N.m (100 kgf/cm, 87 in.lbf)
- Close the terminal cap.
- Connect the starter assembly connector.
- Install the starter assembly to the cylinder block sub-assembly with the 2 bolts.
- INSTALL FLYWHEEL HOUSING SIDE COVER
- Align the protrusion with the cylinder block sub-assembly and engage the claw as shown in the illustration to install the flywheel housing side cover.NOTE:
- Make sure the claw makes a click sound, indicating that it fits tightly.
- Replace the flywheel housing side cover with a new one if the claw does not fit tightly or is deformed.
- Align the protrusion with the cylinder block sub-assembly and engage the claw as shown in the illustration to install the flywheel housing side cover.
- INSTALL FRONT ENGINE MOUNTING INSULATOR
Refer to INSTALLATION [08/2020 - ]
- CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Refer to PROCEDURE - Step 2