LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2019 >> ES 350 Luxury >> Repair and Diagnosis >> External Pages >> Different car >> Section 33 (Hybrid Battery Control System - Service Information (3 Of 3)) >> Combination Switch >> Inspection [06/2018 - ] >> Procedure

Inspection [06/2018 - ]: Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Lexus ES 300h, 2023 Lexus ES 300h, 2022 Lexus ES 300h, 2021 Lexus ES 300h, and 2020 Lexus ES 300h. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSPECT EV DRIVE MODE SWITCH (NO. 3 COMBINATION SWITCH ASSEMBLY) 
    1. Inspect EV mode switch (No. 2 combination switch assembly)
      1. Measure the resistance according to the value(s) in the table below.
        GTY811838Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
        *a Component without harness connected
        (EV Drive Mode Switch (No. 3 Combination Switch Assembly))

        Standard Resistance

        Tester Connection Condition Specified Condition
        G45-5 (S) - G45-2 (E) EV drive mode switch (No. 3 combination switch assembly) being pushed and held Below 1 Ω
        EV drive mode switch (No. 3 combination switch assembly) not pushed 10 kΩ or higher

        If the result is not as specified, replace the EV drive mode switch (No. 3 combination switch assembly).

scientia non olet · About LEMON Manuals