DTC P0195-11: Engine Oil Temperature Sensor Circuit Short to Ground [06/2018 - 07/2019]: Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Lexus ES 300h, 2023 Lexus ES 300h, 2022 Lexus ES 300h, 2021 Lexus ES 300h, and 2020 Lexus ES 300h. However, it is still accessible from the selected car via links, so may be relevant.
- READ VALUE USING TECHSTREAM (CHECK FOR SHORT IN WIRE HARNESS)
*1 Engine Oil Temperature Sensor *2 ECM - Disconnect the engine oil temperature sensor connector.
- Connect the Techstream to the DLC3.
- Turn the power switch on (IG).
- Turn the Techstream on.
- Enter the following menus: Powertrain / Engine / Data List / Engine Oil Temperature Sensor.
Powertrain > Engine > Data List
Tester Display Engine Oil Temperature Sensor - According to the display on the Techstream, read the Data List.
OK
Techstream Display Specified Condition Engine Oil Temperature Sensor -40°C (-40°F) Result
Proceed to OK NG
Result:
OK
REPLACE ENGINE OIL TEMPERATURE SENSOR. Refer to REMOVAL [06/2018 - 10/2019]
Result:
NG
See step 2
- CHECK HARNESS AND CONNECTOR (ENGINE OIL TEMPERATURE SENSOR - ECM)
- Disconnect the engine oil temperature sensor connector.
- Disconnect the ECM connector.
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition C64-1 or C88-123 (THEO) - Body ground and other terminals Always 10 kΩ or higher Result
Proceed to OK NG
Result:
OK
REPLACE ECM. Refer to REMOVAL [06/2018 - 08/2020]
Result:
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR