DTC P0105-15: Manifold Absolute Pressure / Barometric Pressure Sensor Circuit Short to Battery or Open [06/2018 - 08/2020]: Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Lexus ES 300h, 2023 Lexus ES 300h, 2022 Lexus ES 300h, 2021 Lexus ES 300h, and 2020 Lexus ES 300h. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK HARNESS AND CONNECTOR
*a Front view of wire harness connector
(to Manifold Absolute Pressure Sensor)HINT:
Make sure that the connector is properly connected. If it is not, securely connect it and check for DTCs again.
- Disconnect the manifold absolute pressure sensor connector.
- Turn the power switch on (IG).
- Measure the voltage according to the value(s) in the table below.
Standard Voltage
Tester Connection Condition Specified Condition C59-3 (VC) - C59-1 (E2) Power switch on (IG) 4.75 to 5.25 V C59-2 (PIM) - C59-1 (E2) Power switch on (IG) 1.2 to 5.25 V - Turn the power switch off and wait for at least 30 seconds.
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition C59-1 (E2) - Body ground Power switch off Below 1 Ω C59-3 (VC) - C59-2 (PIM) Power switch off 171 to 189 kΩ Result
Proceed to OK NG
Result:
OK
REPLACE MANIFOLD ABSOLUTE PRESSURE SENSOR. Refer to REMOVAL [06/2018 - ]
Result:
NG
See step 2
- CHECK HARNESS AND CONNECTOR (MANIFOLD ABSOLUTE PRESSURE SENSOR - ECM)
- Disconnect the manifold absolute pressure sensor connector.
- Disconnect the ECM connector.
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition C59-1 (E2) - C88-119 (EPIM) Always Below 1 Ω C59-2 (PIM) - C88-120 (PIM) Always Below 1 Ω C59-2 (PIM) or C88-120 (PIM) - Other terminals Always 10 kΩ or higher Result
Proceed to OK NG
Result:
OK
REPLACE ECM. Refer to REMOVAL [06/2018 - 08/2020]
Result:
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR