DTC P00B1-11: Radiator Coolant Temperature Sensor Circuit Short to Ground [08/2020 - 08/2021]: Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Lexus ES 300h, 2023 Lexus ES 300h, 2022 Lexus ES 300h, 2021 Lexus ES 300h, and 2020 Lexus ES 300h. However, it is still accessible from the selected car via links, so may be relevant.
- INSPECT NO. 2 ENGINE COOLANT TEMPERATURE SENSOR
- Inspect the No. 2 engine coolant temperature sensor.
Refer to PROCEDURE - Step 2
Result
Proceed to OK NG
Result:
NG
REPLACE NO. 2 ENGINE COOLANT TEMPERATURE SENSOR. Refer to REMOVAL [08/2020 - 08/2021]
Result:
OK
See step 2
- Inspect the No. 2 engine coolant temperature sensor.
- CHECK HARNESS AND CONNECTOR (NO. 2 ENGINE COOLANT TEMPERATURE SENSOR - ECM)
- Disconnect the No. 2 engine coolant temperature sensor connector.
- Disconnect the ECM connector.
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition C87-2 or C88-129 (THTW) - Body ground and other terminals Always 10 kΩ or higher Result
Proceed to OK NG
Result:
OK
REPLACE ECM. Refer to REMOVAL [08/2020 - 08/2021]
Result:
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR