DTC C1AE8-96: Ultrasonic Sensor (Rear Right Center) Component Internal Failure [09/2022 - ]: Procedure

1. According to the display on the GTS, check for DTCs.

   Body Electrical > Clearance Warning > Trouble Codes 

2. According to the display on the GTS, clear the DTCs.

   Body Electrical > Clearance Warning > Clear DTCs 

3. Recheck for DTCs.

   Body Electrical > Clearance Warning > Trouble Codes 

   Result

   Result	Proceed to
   No DTC is output	A
   "C1AE8-96" is output	B
   "C1AE8-96" and "C1AE8-87" are output	C

Result: 

A 

USE SIMULATION METHOD TO CHECK. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [06/2018 - ] 

Result: 

C 

GO TO OTHER FLOWCHART (C1AE8-87). Refer to  DTC C1AE8-87: Ultrasonic Sensor (Rear Right Center) Missing Message [09/2022 - ]  

Result: 

B 

See step  2

1. Replace the rear center ultrasonic sensor RH with a new or normally functioning one.

   Refer to REMOVAL [09/2022 - ]

   HINT: 

   To check if the ultrasonic sensor is functioning correctly, replace it with another ultrasonic sensor.

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  3

1. According to the display on the GTS, check for DTCs.

   Body Electrical > Clearance Warning > Trouble Codes 

2. According to the display on the GTS, clear the DTCs.

   Body Electrical > Clearance Warning > Clear DTCs 

3. Recheck for DTCs.

   Body Electrical > Clearance Warning > Trouble Codes 

   Result

   Result	Proceed to
   No DTC is output	A
   "C1AE8-96" is output	B

Result: 

A 

END (REAR CENTER ULTRASONIC SENSOR RH WAS DEFECTIVE) 

Result: 

B 

REPLACE CLEARANCE WARNING ECU ASSEMBLY. Refer to  REMOVAL [09/2022 - ]