Typical Enabling Conditions
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Lexus ES 300h, 2023 Lexus ES 300h, 2022 Lexus ES 300h, 2021 Lexus ES 300h, and 2020 Lexus ES 300h. However, it is still accessible from the selected car via links, so may be relevant.
P0400, P0402 EXCEPT MEXICO MODELS
| Monitor runs whenever the following DTCs are not stored | None |
| Time after engine started | 3 seconds or more |
| Time after engine fuel cut | 2.6 seconds or more |
| Engine speed | 950 to 1600 rpm |
| Vehicle speed | 21 km/h (13 mph) or more |
| Engine coolant temperature | 75°C (167°F) or higher |
| Battery voltage | 11 V or higher |
| Intake air temperature | -10°C (14°F) or higher |
| Atmospheric pressure | 76 kPa(abs) [11 psi(abs)] or higher |
P0401 FOR MEXICO MODELS
| Monitor runs whenever the following DTCs are not stored | None |
| Time after engine started | 3 seconds or more |
| Time after engine fuel cut | 2.6 seconds or more |
| Engine speed | 950 to 1600 rpm |
| Vehicle speed | 21 km/h (13 mph) or more |
| Engine coolant temperature | 75°C (167°F) or higher |
| Auxiliary battery voltage | 11 V or higher |
| Intake air temperature | -10°C (14°F) or higher |
| Atmospheric pressure | 76 kPa(abs) (11 psi(abs)) or higher |
P0401 EXCEPT MEXICO MODELS
| Monitor runs whenever the following DTCs are not stored | P0010, P1360, P1362, P1364, P1366, P2614 (Motor drive VVT system control module) P0011 (VVT system - advance) P0012 (VVT system - retard) P0013 (Exhaust VVT oil control solenoid) P0014 (Exhaust VVT system - advance) P0015 (Exhaust VVT system - retard) P0016 (VVT system - misalignment) P0017 (Exhaust VVT system - misalignment) P0031, P0032, P101D (Air fuel ratio sensor (sensor 1) heater) P0101, P0102, P0103 (Mass air flow meter) P0106, P0107, P0108 (Manifold absolute pressure) P0111, P0112, P0113 (Intake air temperature sensor) P0116, P0117, P0118 (Engine coolant temperature sensor) P0121, P0122, P0123, P0222, P0223, P2135 (Throttle position sensor) P0125 (Insufficient coolant temperature for closed loop fuel control) P014C, P014D, P015A, P015B, P2195, P2196, P2237, P2238, P2239, P2252, P2253 (Air fuel ratio sensor (sensor 1)) P0171, P0172 (Fuel system) P0327, P0328 (Knock control sensor) P0335, P0337, P0338 (Crankshaft position sensor) P0340, P0342, P0343 (Camshaft position sensor) P0365, P0367, P0368 (Exhaust camshaft position sensor) P0489, P0490 (EGR control circuit) P0500 (Vehicle speed sensor) P0657, P0658, P2102, P2103, P2111, P2112, P2119 (Throttle actuator) P106A (Evaporative emission control system pressure sensor - manifold pressure sensor correlation) P11EA, P11EC, P11ED, P11EE, P11EF, P219A, P219C, P219D, P219E, P219F (Air-fuel ratio imbalance) P2228, P2229 (Atmospheric pressure sensor) |
| Time after engine started | 3 seconds or more |
| Time after engine fuel cut | 2.6 seconds or more |
| Engine speed | 950 to 1600 rpm |
| Vehicle speed | 21 km/h (13 mph) or more |
| Engine coolant temperature | 75°C (167°F) or higher |
| Battery voltage | 11 V or higher |
| Intake air temperature | -10°C (14°F) or higher |
| Atmospheric pressure | 76 kPa(abs) [11 psi(abs)] or higher |