Installation [08/2020 - ]: Procedure

WARNING: This page is about a different car, the 2024 Lexus ES 250, 2023 Lexus ES 250, 2022 Lexus ES 250, and 2021 Lexus ES 250. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL GENERATOR ASSEMBLY
1. Install the generator assembly with the bolt and 2 nuts.
  Torque: 25 N.m (255 kgf/cm, 18 ft.lbf)
2. Engage the clamp.
3. Connect the E.F.I. vacuum sensor assembly (manifold absolute pressure sensor) connector.
4. Install the wire harness clamp bracket to the generator assembly with the bolt.
  Torque: 10 N.m (102 kgf/cm, 7 ft.lbf)
5. Connect the wire harness to terminal B with the nut.
  Torque: 9.8 N.m (100 kgf/cm, 87 in.lbf)
6. Close the terminal cap.
7. Connect the generator assembly connector.
INSTALL V-RIBBED BELT
Refer to INSTALLATION [08/2020 - ]
INSTALL INLET AIR CLEANER ASSEMBLY
Refer to PROCEDURE - Step 47 [08/2020 - 08/2021] , or refer to PROCEDURE - Step 48 [08/2021 - ]
INSTALL COOL AIR INTAKE DUCT SEAL
Refer to PROCEDURE - Step 2 [06/2018 - 08/2021] , or refer to PROCEDURE - Step 2 [08/2021 - 09/2022] , or refer to PROCEDURE - Step 2 [09/2022 - ]
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Refer to PROCEDURE - Step 2