DTC P0115-2A: Engine Coolant Temperature Sensor 1 Signal Stuck in Range [09/2022 - ]: Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Lexus ES 300h, 2023 Lexus ES 300h, 2022 Lexus ES 300h, 2021 Lexus ES 300h, and 2020 Lexus ES 300h. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0115-2A)
- Connect the Techstream to the DLC3.
- Turn the power switch on (IG).
- Turn the Techstream on.
- Enter the following menus: Powertrain / Engine / Trouble Codes.
- Read the DTCs.
Powertrain > Engine > Trouble Codes
Result
Result Proceed to DTC P0115-2A is output A DTC P0115-2A and other DTCs are output B HINT:
If any DTCs other than P0115-2A are output, troubleshoot those DTCs first.
Result:
B
GO TO DTC CHART. Refer to DIAGNOSTIC TROUBLE CODE CHART [09/2022 - ]
Result:
A
See step 2
- INSPECT WATER INLET WITH THERMOSTAT SUB-ASSEMBLY
- Inspect the water inlet with thermostat sub-assembly (thermostat opening temperature).
Refer to INSPECTION [08/2021 - ]
HINT:
Perform "Inspection After Repair" after replacing the engine coolant temperature sensor.
Refer to INITIALIZATION [08/2021 - ]
Result
Proceed to OK NG
Result:
OK
REPLACE ENGINE COOLANT TEMPERATURE SENSOR. Refer to REMOVAL [09/2022 - ]
Result:
NG
REPLACE WATER INLET WITH THERMOSTAT SUB-ASSEMBLY. Refer to REMOVAL [08/2021 - ]
- Inspect the water inlet with thermostat sub-assembly (thermostat opening temperature).