DTC P0110-2A: Intake Air Temperature Sensor 1 Bank 1 Signal Stuck in Range [08/2020 - 08/2021]: Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Lexus ES 300h, 2023 Lexus ES 300h, 2022 Lexus ES 300h, 2021 Lexus ES 300h, and 2020 Lexus ES 300h. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0110-2A)
- Connect the Techstream to the DLC3.
- Turn the power switch on (IG).
- Turn the Techstream on.
- Enter the following menus: Powertrain / Engine / Trouble Codes.
- Read the DTCs.
Powertrain > Engine > Trouble Codes
Result
Result Proceed to DTC P0110-2A and other DTCs are output A DTC P0110-2A is output B HINT:
- If any DTCs other than P0110-2A are output, troubleshoot those DTCs first.
- Perform "Inspection After Repair" after replacing the mass air flow meter sub-assembly.
Refer to INITIALIZATION [08/2020 - 08/2021]
Result:
A
GO TO DTC CHART. Refer to DIAGNOSTIC TROUBLE CODE CHART [08/2020 - 08/2021]
Result:
B
REPLACE MASS AIR FLOW METER SUB-ASSEMBLY. Refer to REMOVAL [06/2018 - ]