Power Trunk Lid does not Operate Using Outside Switch [08/2021 - ]: Procedure

1. Check that the power trunk lid operates normally.

   Refer to OPERATION CHECK [06/2018 - 09/2022] , or refer to OPERATION CHECK [09/2022 - ]

   Result

   Result	Proceed to
   Power trunk lid operates normally	A
   Power trunk lid does not operate normally	B

Result: 

B 

GO TO POWER TRUNK LID CANNOT BE OPERATED FREQUENTLY. Refer to  Power Trunk Lid cannot be Operated Frequently [08/2021 - ]  

Result: 

A 

See step  2

1. Read the Data List according to the display on the Techstream.

   Body Electrical > Back Door > Data List 

   Tester Display	Measurement Item	Range	Normal Condition	Diagnostic Note
   PBD Close Switch	Door control switch signal	OFF or ON	OFF: Door control switch off ON: Door control switch on	-

   Body Electrical > Back Door > Data List 

   Tester Display
   PBD Close Switch

   OK

   The Data List item changes according to the operation of the door control switch.

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE LUGGAGE CLOSER MOTOR ASSEMBLY. Refer to  REMOVAL [08/2021 - ] 

Result: 

NG 

See step  3

1. Remove the door control switch.

   Refer to REMOVAL [06/2018 - ]

2. Inspect the door control switch.

   Refer to INSPECTION [06/2018 - ]

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REPLACE DOOR CONTROL SWITCH. Refer to  REMOVAL [06/2018 - ] 

Result: 

OK 

See step  4

1. Disconnect the R24 luggage closer motor assembly connector.
2. Measure the resistance according to the value(s) in the table below.
   STANDARD RESISTANCE
   
   

   Tester Connection	Condition	Specified Condition
   R16-4 (CLS) - R24-9 (LDDN)	Always	Below 1 Ω
   R16-1 (E) - Body ground	Always	Below 1 Ω
   R16-4 (CLS) or R24-9 (LDDN) - Body ground	Always	10 kΩ or higher

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE LUGGAGE CLOSER MOTOR ASSEMBLY. Refer to  REMOVAL [08/2021 - ] 

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR